Suite Series
New Generation Suite Series Radiators provide architects and contractors with ease of calculation and drawing as well as quality in constructions. In the heating systems of all modern buildings, especially in cases where the volumes need to be adjusted to different temperatures, it responds to all kinds of heat needs with different sizes produced.
Thanks to the untouched surface coating system, it is extremely resistant to all weather conditions, moisture and impacts.
In addition, it provides the opportunity to be used safely in multi-storey buildings and high operating pressures by being subjected to 100% leakage control.
ŞAHBAZ A.Ş. is advancing rapidly towards development and targets with its understanding that prioritizes innovation and difference. By adopting modern management as a principle, it prioritizes quality in order to meet market demands and assurance in its products.
1 – BOTTOM ADVERTISING CONNECTION
It can be applied to all models. The “Direction Plug” supplied with the radiator free of charge is placed between 3-4 slices in radiators from the direction of hot water inlet to the 10th slice, and between 4-5 slices in radiators larger than 10 slices. The air vent valve should be installed across the direction plug.
2 – CROSS CONNECTION
It can be applied to all models. Hot water inlet and air vent valve must be at the top.
3 – PARALLEL CONNECTION
It can be applied to all models. Hot water inlet and air vent valve must be at the top.
4 – BOTTOM INPUT AND OUTPUT (HB) CONNECTION
It can be applied to all models. Direction plug is installed during factory manufacturing. Hot water inlet should be made from the outside and cold water outlet should be made from the inside. If hot water is input from the opposite side, only the 4th slice will be heated.
5 – COMPACT INTEGRATED THERMOSTATIC VALVE CONNECTION
It can be applied to all models. Direction plug is installed during factory manufacturing. Hot water inlet should be made from the outside and cold water outlet should be made from the inside. The thermostat and its special core should be the same with the hot water inlet direction.
6 – BY-PASS CONNECTION
